This is a program i created from scratch. Yes DLC Hammer is named after PCM Hammer for GM's because its intention is the same as PCM Hammer. Free and open source for everyone to use, work with and evolve. DLC Hammer support 98-04 T444E and DT466E trucks. it may support other international trucks in that year range but i am not sure if it will and it has not been tested on anything else other than the 2 types mentioned. I have only tested it with 2 data cables, a genuine scanmatic SM2-pro with an OBD to 9 pin adapter from amazon and the US-RS485 cable that is included with the orion software suite from powerhungry performance. Other J2534 based cables will most likely work if they have RP1210 support for them. I would imagine one could also build their own USB-RS485 cable with 6 or 9 pin diag connector end themselves for relateively cheap.
what it can do
-Supports J2534 based cables that have RP1210 support plus USB-RS485 COM port based cables.
-MID scanner to see what modules are talking on the busses truck and if you need to pull fuses to read and flash successfully with the ECU.
-Fault code scanner that reads faults just like servicemaxx with descriptions. can read, save to a txt file and clear your fault codes.
-Checksums tab lets you load everything from full flash dump reads to data port reads that are strategy and calibration only and will always check and correct the checksums for the strategy and calibrations.
-Flash tab is where you can read or write the strategy and calibration part of your ECU. the read is a standard BIN file. no crazy encryption or unnecessary protection.
-cross checker tab is exactly that. it will take a BIN file from an ECU you want to use and see if there is a compatible software version for the engine you want to run. this is limited to the database of files i had out of the box but you can expand the database in your program and share the list updates with others on the forum of you feel the need. it does not come with BIN's because navistar is probably already mad enough at me for making this. finding the BIN's is up to the community actually sharing stock file reads from the the trucks for others to use. Yes DT466E and T444E ECU's are one in the same on a hardware level. the only thing that makes them different is the firmware that is running on them.
This program is intended for personal use, it was never intended for commercial use or for monetary gain. The source code is included in the zip file for the program for those looking to expand the program or understand how it works. This is a true open source project end to end. I built this originally to help myself help several friends repair their international trucks after discovering the severe gate keeping and financial pay walls that people have been using to block the average truck owner from accessing these types of tools for decades. the end of that is now. your welcome.
Navistar DLC Hammer
-
dubcrazy8392
- Posts: 38
- Joined: Fri Jul 18, 2025 10:57 pm
- cars: -1981 6.0L LQ4 swapped C10 (aka lumpy)
-2000 silverado 2500 (daily work horse that does it with style)
Navistar DLC Hammer
You do not have the required permissions to view the files attached to this post.