Ecotec v6 heads
-
Wade
- Posts: 1247
- Joined: Sun Jul 10, 2016 8:29 pm
- cars: Vr 5.0 statesman vr exec 5.0 turbo vy clubsport
Ecotec v6 heads
Are the valve seats machined directly into the head casting on the heads?
-
vlad01
- Posts: 8600
- Joined: Mon Oct 08, 2012 8:41 am
- cars: VP I S
VP I executive
VP II executive
VP II executive #2 - Location: Kyneton, Vic
Re: Ecotec v6 heads
No, there are seats pressed in them. It's not obvious due to how cleanly they are blended from factory. Buick are the same. I have had exhaust seats machined out and replaced twice on the Buick heads before due to excessive erosion.
-
Rhysk94
- Posts: 241
- Joined: Sun Mar 15, 2020 9:25 am
- cars: VE SS-V
VY V6 Turbo “Ecojet”
FG XR6 Turbo
VY V6 Stocker Farm Hack
VY V6 Turbo Competition Drift Car
VY V6 L67 Seat Time Drift Car
N80 Toyota Hilux
VZ SS - Location: Perth
Re: Ecotec v6 heads
Definitely pressed, have had a few fall out
-
Wade
- Posts: 1247
- Joined: Sun Jul 10, 2016 8:29 pm
- cars: Vr 5.0 statesman vr exec 5.0 turbo vy clubsport
Re: Ecotec v6 heads
I think I need to wear my glasses cause I can’t see em.
-
vlad01
- Posts: 8600
- Joined: Mon Oct 08, 2012 8:41 am
- cars: VP I S
VP I executive
VP II executive
VP II executive #2 - Location: Kyneton, Vic
Re: Ecotec v6 heads
You basically can't. On a few heads I've see some small voids in the casting right on the edge of the seat, so it was obvious then, but nearly all heads are machined with the angles going some amount past the seat material, so it's fully blended in. Because they are cast in the Saginaw casting plant, their grey iron is of high quality and looks less grey than typical grey iron. It all looks the same once it's machined/blended.
To make it even more hidden, they heat treat the seats in place so the whole area gets the same uniform treated look. I have NOS Buick heads and like you say, looks like the seats are the same as the rest of the head.
To make it even more hidden, they heat treat the seats in place so the whole area gets the same uniform treated look. I have NOS Buick heads and like you say, looks like the seats are the same as the rest of the head.
-
Wade
- Posts: 1247
- Joined: Sun Jul 10, 2016 8:29 pm
- cars: Vr 5.0 statesman vr exec 5.0 turbo vy clubsport
Re: Ecotec v6 heads
They don’t look too bad for a std head. Probably do with some work in the bowl area and some blending in the combustion chambers. Other than that, not too bad