Ive been playing around with these things for most of this year and have found them to be very hardy and hard to kill. I have them in my own cars and the cool add ons you can do using an ESP32 Makes them very bloody useful.
Ive built 5 complete FLASH converted PCM'S and all behave well ive got a VT PCM Carrier which is by far the easiest to Convert. But the Flash 060A and 060b PCM'S are the Bomb!
Few options
Send me your PCM I'll convert it NZD$400, 500 if i need to source one as thin on ground and not cheap in Nz. for VX-VY you'll get it back loaded with The1's v1.0a ready to start tuning. This will include modification to housing adding Usb C bulkhead connector.
Interposer boards bare $60
Interposer Board fitted out with onerom $250 ready to add to your own PCM (setup yourself)
VT ONEROM fit and test $200 (you supply eprom carrier core) I'll ship you one thats ready to rock n roll.
Genuine ONEROM's i may be able to supply but exchange rate fluctuations may change price POA.
ECOTEC V6 ONEROM EMULATORS
-
Muncie
- Posts: 249
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
ECOTEC V6 ONEROM EMULATORS
You do not have the required permissions to view the files attached to this post.
Last edited by Muncie on Tue Nov 17, 2026 10:03 pm, edited 1 time in total.
-
Muncie
- Posts: 249
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
Re: ECOTEC V6 ONEROM EMULATORS
Current spec the modifications are actually reversible on the flash PCM's J4 gets a socket and 4 pin connector, you can solder directly to board as well for a permanent install.
Self install steady hands needed and surface mount Hot air soldering is required probably a 7 out of 10 for skill due to a heap of de soldering clean up and adding wires to the U11 pad.
Self install steady hands needed and surface mount Hot air soldering is required probably a 7 out of 10 for skill due to a heap of de soldering clean up and adding wires to the U11 pad.
-
Muncie
- Posts: 249
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
Re: ECOTEC V6 ONEROM EMULATORS
**Special**
This interposer is used but will go again if you want a shortcut to all the soldering.
As you see it $40
This interposer is used but will go again if you want a shortcut to all the soldering.
As you see it $40
You do not have the required permissions to view the files attached to this post.