Ok Attached in the Zip file are to files
The Bin file is the Orginal cheap read out of the car (Slightly modified spark table), xdf $5D required
Second is my attemp to convert to $12P v1.1.1. The thing I'm not sure about is the spark curve.
I was hoping some one could just run an eye over it before i put the program in the car.
Cheers
$12p Converation
-
ToyHicko
- Posts: 226
- Joined: Tue May 19, 2009 9:51 am
- cars: Toyota Celica/VN Bash Car
- Location: Coffs Harbour, Australia
$12p Converation
You do not have the required permissions to view the files attached to this post.
-
Holden202T
- Posts: 10435
- Joined: Sat Feb 28, 2009 11:05 am
- Location: Tenambit, NSW
Re: $12p Converation
it doesn't look too bad, the only thing i changed was the extension slope from 4800 rpm + .... also copied the map a spark to map b
You do not have the required permissions to view the files attached to this post.
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
ToyHicko
- Posts: 226
- Joined: Tue May 19, 2009 9:51 am
- cars: Toyota Celica/VN Bash Car
- Location: Coffs Harbour, Australia
Re: $12p Converation
Ok thanks Holden202 that was my biggest worry. But going off the oringal tune that should of be pretty close to the same.