Bigger Throttle Body, TPS reference changes!

[The1]

here's the logs before and after, though just keep in mind the after included the force motor table there, i tweaked up with extra pressure down low speed. I might give it another 0.05% tomorrow morning and watch the log again.

[gbonola]

well if the required change is 12.7% as yoda69 pointed out earlier in this thread, you can try adjusting the value from my last post from 0x60 to 0x6D.
What bin are you using?

Sorry i took so long to get back , got stuck with work, just got home.
i'm using vxv6.bin. just blown away at all the reponses.

[The1]

here's this arvo's log with 0.75%

[The1]

ok pretty much done now 0.79 is the spot, also smoothed the bottom of the FM table to clean up low end shift click, all nice and smooth now, also changed upshift pressures to 10psi to knock the shift slip on the head a bit, those settings are in the new xdf holden202 just put up.

[gbonola]

Great work, I redid my vu and trans is changing great. Only thing it thumps a bit when engaging drive or reverse, not to bad. where do I find new .xdf holden202 put up.
Thanks.

[The1]

the new vs v6 xdf's if that's what your refering to, are https://pcmhacking.net/forums/viewtopi ... &t=5#p5588

[gbonola]

I thought it was a vx xdf's.