vs auto problem

[holden08]

hi my mate has a vs v6 auto it has lost 1st 3rd and 4th gear only works in second gear. he has a vp v6 auto gearbox can he use that he also has a vs manual ecu but it wont know about tcc lockup thanks is there a way to use the vp auto box thanks

[Holden202T]

you could make it work with a vs v6 auto pcm i think just disable the auto codes .... not 100% sure on that....

another option is you can always run it on a vn/vp computer and loom etc ...

[The1]

do you have reverse? Could be just shift solenoids

[holden08]

rever works sorta and starts to slip some gears work then slip bad changed fluid and filter made it a little better

[holden08]

im not to sure if the vs pcm will do the vp tcc lockup wish i knew about the software side of things lol

[The1]

both 1-2 and 2-3 has to be ON for reverse, if you have 2nd and some reverse then 2-3 could be stuck ON, but could be anything, scantool can command solenoids on and off

1st gear 1-2 ON 2-3 ON
2nd gear 1-2 OFF 2-3 ON
3rd gear 1-2 OFF 2-3 OFF
4th gear 1-2 ON 2-3 OFF

[holden08]

the transmission fluid was very dirty and alot of metal filings in it

[The1]

not good then

[holden08]

yea so would a vs manual ecu somehoe run a vp gearbox the only issue is the tcc lockup

[The1]

yeh if it's 700 box then it's hydraulic so only tcc wouldn't lockup, but you could prob wire up a switch if you wanted to enable it when you want, seen guys do that before.