Having a few issues burning a particular bin.
It's a VS V8 auto realtime / wideband mod bin.
I have the offset right ( 64k bin ) so no offset needed on a VS Auto memcal
Just to make sure I didn't have a burning issue, I burnt a OSE bin to a spare memcal, no problems.
I have burnt it previously with no issues? Even tried a different memcal, same problem.
The bin was grabbed off the NVRAM via the flashtool. Even tried the origonal BWFU_Mod_Wideband bin and no go.
Any help with this one would be appreciated.
Trouble burning a bin
-
- Posts: 88
- Joined: Thu Oct 07, 2010 10:45 pm
- cars: VR Ute with VS V6 Getrag driveline
VE SSV Ute
VS Ute - Location: Campbelltown NSW
Trouble burning a bin
- Attachments
-
- Dale304stato.bin
- (64 KiB) Downloaded 281 times
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: Trouble burning a bin
Looks like a couple of things, a few bits of code missing but one thing was the wonderful GM mode 2 bug. The very last byte of the bin ends up being wrong, its fixed in 12P but factory code gets it wrong.
Hopefully the attached bin sorts it out.
Hopefully the attached bin sorts it out.
- Attachments
-
- BWFU_mod_Wideband_Dale304.bin
- (64 KiB) Downloaded 277 times
-
- Posts: 88
- Joined: Thu Oct 07, 2010 10:45 pm
- cars: VR Ute with VS V6 Getrag driveline
VE SSV Ute
VS Ute - Location: Campbelltown NSW
Re: Trouble burning a bin
Thanks mate. Did the trick!
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Trouble burning a bin
i feel your pain, i bashed my head with this same issue a while back!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread