Vr auto to manual with vn loom

[Khaosinc]

Hi,

Im upto putting the wiring loom on my engine, only thing is the manual loom and ecu (808 with sxr emulator and nvram memcal with 12p tune) is from a vn commodore and it has a 1 wire oxygen sensor on the header. I have extractors on my car which is a vr commodore with a 4 wire oxygen sensor that is at the end of the y pipe. Can i add the extra wires into the loom and wire it up like a vr manual and will the heating wires for the vr oxygen sensor work with the 12p tune? Or would i be better splitting the auto loom and repinning it into the manual plugs and removing the auto part of the loom and using the manual speed sensor part.

Thanks. 

[Holden202T]

just add the wires for the o2 .... the 4 wire ones are normally purple for signal, 2 blacks for ground for heater and sensor and then the white one is +12v for the heater, and wire it up so that gets power when the ignition is on.

[Khaosinc]

Okay i can get that from around the right area.

Thanks.