Second that, looks a beast thoughHolden202 wrote:love the rear end pic, you know its so wrong for that car, but it looks so right
DELCOS NEW RIDE
Re: DELCOS NEW RIDE
Re: DELCOS NEW RIDE
haha nice mod there delco, hows that go over stock plenum?
- delcowizzid
- Posts: 5630
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
dunno yet will dial in the cam this week and bolt it all back on and fire it up do some skids then out comes the T700 and in goes the built T400
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: DELCOS NEW RIDE
i guess the smooth round edge of it will flow nicer than a square box.
- Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: DELCOS NEW RIDE
i assume it only just fits under the bonnet ?
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5630
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
yeah its close lol if he ever fits new mounts it wont fit 

If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- delcowizzid
- Posts: 5630
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
well today i pulled the plugs out the VX for a bit of a look and see if i should replace them. 3 were worn as shit on the earth and the other 3 were worn on the center electrode due to one side firing the spark at the earth and the other firing at the pin and the gaps are now around 2mm LOL better buy some more this week also when i pulled out the last plug No1 i was more shocked its covered in the dredded alloy pepper seems i must have a blocked injector and that cylinder is pinging its nuts off better fit another tomorrow
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: DELCOS NEW RIDE
damn, hows the tuning going on that thing, flashed it up yet?
- delcowizzid
- Posts: 5630
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
nah stock as a rock want to get it running smoother first and lucky i waited or it would be dead allready LOL
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: DELCOS NEW RIDE

No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread