EV6 into S1 VN

[ShawtyNate]

Does anyone have the wiring diagrams for the YE51 Plug near the battery? also the larger grey one if i have to change anything, this is for a VR engine into a VN series one.

[The1]

not quite sure what the whole post is about, im thinking using ev6 injectors in a vn.

Usually not a good idea to run lower ohm injectors in system designed for higher ohm injectors, will pull more amps from the drivers.

[Dazza92VP]

ive been running standard vs injectors which are apparently 12ohm on the old 808 and have yet to cook the injector drivers been running them for about 2 years now

[The1]

may handle it fine then, not enough of a difference.

[antus]

yes, from what google tells me ev6 are high impedance and are fine. low impedance should be avoided (less than about 4 ohm). just commodore spares in adelaide can probably help with the connectors and post them, but i have no idea what they'd charge. http://www.justcommodorespares.com.au/ i have no business relationship with them. have just been a customer.

[VK_3800]

YE51 pinout looking at connector with clip on top

120, 240, 465
481, 102, 540

Locations on wiring diagrams: 10, 105, 107, 111, 115, 133

Wiring diagrams:

[ShawtyNate]

I am running full vr loom and ecu with the vr engine. The plug is different so I have cut the plug off the series one vn loom. Now it's just wiring up that plug.

[charlay86]

Pretty sure they aren't polarized, just try connect 12v to them and see if they click.
Essentially they are DC solenoids.

[ShawtyNate]

im not talking about the injectors, i need to rewire the black plug near the relay box and the grey one next to the black one.