I have an $11 & $12 .ads that I put together when I was bored one night, that works with Tunerpro if any one is interested. Will probably work with VS series as well( $5A,$83 etc) , but haven't tested it yet. It needs some tidying up, but works well.
Have been running '165 with $12 in my 355 powered 80 series toyota also in a lot of other tuning jobs, then plug that tune & '808 back into car. $12 .ads works well with the '165, '6424, '3082 and thats all I have tested. Map tracing works well also once you have it all setup properly. Scanerpro seems to be more configurable as a dashboard.
VN Commodore ECU update
-
fabmec
- Posts: 12
- Joined: Thu Oct 08, 2009 1:25 pm
- cars: Landcruiser 355 80 series
Landcruiser Isuzu powered 45 series
Au Falcon - Location: Macalister, Qld
-
Holden202T
- Posts: 10435
- Joined: Sat Feb 28, 2009 11:05 am
- Location: Tenambit, NSW
Re: VN Commodore ECU update
they would be quite handy to alot of people i'd say, post them up if your keen.
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
mag
- Posts: 327
- Joined: Thu Apr 02, 2009 11:21 pm
- cars: VN Commodore
- Location: Blue Mountains NSW
Re: VN Commodore ECU update
Great work fabmec, would be very interested to try $12.
-
fabmec
- Posts: 12
- Joined: Thu Oct 08, 2009 1:25 pm
- cars: Landcruiser 355 80 series
Landcruiser Isuzu powered 45 series
Au Falcon - Location: Macalister, Qld
Re: VN Commodore ECU update
$11,$12,$5A etc vr-vs .ads file attached for tunerpro V4.14.
I use moates extreme aldl & modified cable1, and ostrich 2.0
I use moates extreme aldl & modified cable1, and ostrich 2.0
You do not have the required permissions to view the files attached to this post.
-
mag
- Posts: 327
- Joined: Thu Apr 02, 2009 11:21 pm
- cars: VN Commodore
- Location: Blue Mountains NSW
Re: VN Commodore ECU update
Hi All, been a delay while I waited for the rego renewal before fitting the SC14. Wanted to give myself as much time as possible to complete the install, tune & engineering cert. before rego came round again. Time was not wasted as now have 8192 ALDL & NVRAM upgrade fitted to spare 808. NVRAM burnt with $12S V6 non_vat cal bin, will run first time tomorrow. Many thanks to VL400 for his great work & assistance the 808 upgrade & also fabmec for his ads file that should allow TunerPro RT to log.