Tunerpro 5.00.8075.00

[The1]

Small update, no fixes for the things we have asked yet.

http://tunerpro.net/downloadApp.htm

5.00.8075.00 (General Release) (1/08/13)

Note: Your stored settings will be reset when you run this build.
When browsing for a datalog (XDL) file, the browse now starts in the path of the last XDL loaded
When exporting an XDL to a comma-separated log, double clicking an item in either list will add or remove it
When opening the item finder (Ctrl + F), the input text field now has focus and the text is selected by default.
Fixed a minor bug when patches used the max size data payload of 256 bytes
Fixed unresponsive state in XDF table properties editor when reducing row/col count with out-of-range cell selected
Fixed issue with raw addresses to 16-bit values used in conversions

[VX L67 Getrag]

LOL, some of those were things I asked nice work Mark!!!

Still no fix for the setting hi & lo & then making them beyond this setting & doesn't save beyond it!

but nice all the same!

[The1]

well it's not happy on my laptop, ose plugin crashes when i try to upload to nvram. Also datalog issues on all my machines, if i have a log open and switch between adx's i have open another log and then go back, otherwise the monitor window will be blank.

[The1]

figured out the problem, ose plugin had writing disabled for some reason, so trying to write just crashed TP

[antus]

something not right there. the option is not for writing at all, it should always allow calibration area writing, its just an override for the calibration area only read or write, so people can read complete bins from tunerpro and then while I was at it I decided to add an override for write too, though its intended for developers if they need to apply code patches. It defaults to being cal area only for safety, and should not crash (and didnt on older versions). I'll check it out.

[The1]

Thank Antus, i tested it on the bench with same results, so should be repeatable on your end. No big issue but didn't think to look there after it started doing it when i upgraded.