AEM No Weld O2 Mounts ?? or other no-weld options?

[azuredreama]

Hi!
Has anyone used one of these AEM No Weld mount's with their wideband http://www.aemelectronics.com/no-weld-o ... -inch-1174 ? I'm looking to getting a wideband o2 sensor, but i don't have access to a welder and so i was looking into any other possible options. I wanted to keep the factory o2 sensor on their too so i can run both narrowband and wideband..

I was also looking at the Innovate Exhaust clamps but after reading some forums/reviews, it looks like it can be hard getting accurate readings.

Any suggestions/idea would be appreciated

[The1]

looks good, as long as it seals good.

[antus]

Agree, if it seals its probably ok. I wager that you could find an exhaust shop who would weld in the innovate bung that comes with the kit for about that though. Just hack saw it in half first if you think its too long.

[charlay86]

seems to seal pretty well, there is a video down the bottom of that page where they pressure test it to 50psi

[azuredreama]

Thanks guys! i might give it a go, other people are saying they seal good too.