2 bar map sensor question?

[leathalbusa]

Hi All where do I change the value for a 2bar map sensor?

[antus]

If you mean in 12p? then hit ctrl + f and pick find: "a flag" "with this phrase in the title" and type "map sensor" and click search.

You'll see

Code: Select all

Map A: MAP Sensor Type Selection A \ A:B Clear = 1Bar
Map A: MAP Sensor Type Selection B / A Set = 2Bar, B Set = 3Bar

and the same for map b.

You are probably tuning Map A (map a doesnt refer to the map sensor, it means tune a in the nvram) so for a 2 bar sensor set MAP A: Selection A as checked and MAP A: Selection B as clear

[leathalbusa]

ok so then I click on the second box MapA: Map sensor type selection B/ A set = 2Bar, B set =3bar and I check the set box for this one?

[antus]

No.

A:B Clear = 1Bar
A Set = 2Bar
B Set = 3Bar

So check A for a 2 bar sensor.

[Holden202T]

selection a ticked = 2 bar
selection b ticked = 3 bar
both un-ticked = 1 bar

[Apples]

sounds ok to me but may be a picture lol

[antus]

here you go apples Couldnt help myself.
This is also a visual explanation of how to interpret ascii art for those who have not seen it before.

map bits.png

[leathalbusa]

yeah thatks 202 that is what I was trying to figure out. no ticks in the boxes 1 bar. tick selection a box 2bar and tick both a n b boxes 3 bar..

Now that should make all the tuning problems we have been having go away...

bloody superchargers.

[VL400]

3 bar is not both ticked, just B ticked.

[Apples]

One Bar

one bar.gif

Two Bar

Two bar.gif

Three Bar

Three bar.gif

If I read it right