wiring in wideband and setting it up

[1979project]

Gday guys. iv just set myself up to data log my vx l67 and i have noticed in tp dashboard there is a gauge for wideband now im just woundering what pin on the pcm i wire the wideband output? And what voltages do i set my wideband controller to send. Thanks guys im pretty new to all this so i might have a few more questions once it comes time to tune it.

[The1]

if it's factory tune, not enhanced you need to disconnect the injector monitor line and hookup with your wideband. Leave wideband at default settings and you'l be good to go.

If it's enhanced then you can use either B10 or A5 spare ports and the enhanced adx, you will need to input the calculation for that port into the adx depending on what wideband settings your using and what brand, the calculations are on the first post in the enhanced thread.

If you need more info give us a yell.

[1979project]

Ok cool thanks its just a stock tune atm just slowly setting myself up i will be setting it up with a nv ram soon. Will disconnecting the injector monitor line cause any other issues? Have you tuned any l67s with aftermarket cam's. It has a w2a intercooler atm but looking at a cam change or maybe going turbo. Would you think this is able to be done keeping the maf? Sorry for all the questions ha ha

[1979project]

And is the injector monitor linon pin C14?

[The1]

injector mointor line is pin B12

Yes MAF is fine, stock one will take 10psi or so. After that look at using a LS6 maf with enhanced mod code. https://pcmhacking.net/forums/viewtopi ... =27&t=2518

[1979project]

Also is it ok to just run one o2 sensor or do i need to run one off each bank as it has twin cats?