yeah thats correct and thats why if i use it i'd only use the sucrogen stuff to make sure i know what im getting all the time and don't have to constantly chase my tune!
my mate has a tester for it so i'll use his if needs be hehehe
No matter what the question is, the answer is always more horsepower!
Holden202T wrote:wow not cheap! guess it depends how much you want to have your AFR's right with the change in ethanol content hey.
so VL400 whens it getting added to $12P hahahaha
There is a spare counter input so it might be possible to use that, will depend on the PWM output freq. Or could make the PWM output in to a 0-5V signal and read that instead. One way to have it work would be to change everything AFR to lambda, then use a correction table or scalar for the PWM signal so it can work out the stoich AFR which gets applied to all lamba values. Lots to change!
Found out my trimatic only has 4 clutches in 3rd gear so will be upgrading to 6 plus one more in 2nd gear also full manual valve body and then hopefully it will love it!!
No matter what the question is, the answer is always more horsepower!
well we're ready to go for WSID this sunday, spare box is in and tested ok on the jack stands! welded some new bump stops into the rear to stop the tailshaft hitting the floor before the diff hits the bump stops, and dropped the wastegate spring from ~17psi to less hehehe
i'm not really sure what its going to be cause the 17psi spring is supposed to be 14psi so the 10 that I have in there is likely to be 13psi .... either way this is to drop fuel demand till I can sort out my fuel system upgrades!
either way 13-15 psi (can add a bit more with a screw on the wastegate) should be enough to get close to what I was running before, especially with a hopefully better gearbox and more motor!
11.77 @ 118mph is the target!
now we just need to pray this forecast rain DOESN'T!
No matter what the question is, the answer is always more horsepower!