Mk1 capri, plans, complete noob

[Helical]

If you have any mates that fly R/C aeroplanes you might be able to mount it in a prop balancer to check on the hole drilling effectiveness.

[Holden202T]

you should be able to get it pretty close with the drill method, but yeah if you have a better option for sure!

I know my 36 - 1 trigger wheel had about 10mm hole to offset the one missing tooth!

[antus]

The trick with this will be judging how much to remove where the material is thinner inside of the thick outer part with the teeth.

[Holden202T]

yeah that's right, but just small steps with a drill will be fine

[stevemc32]

If you have any mates that fly R/C aeroplanes you might be able to mount it in a prop balancer to check on the hole drilling effectiveness.

That's a good idea and cheap as chips, here's a hand held balancer delivered for 8 bucks.

http://www.ebay.com.au/itm/RC-Simple-Ha ... 2574fcffd9

[Chubs0191]

Update on the manifold

20130618_165953.jpg

[Holden202T]

that length looks much better

[Chubs0191]

May get shorter yet the plenum is already on the edge of being too large for my liking

[Chubs0191]

One more ridiculous question on the wiring Loom how to I tell wick row of pins is a b c d on the plugs ?

[delcowizzid]

look on the back on the blue clips labeled a b c d and pins 1-20