does anyone have a schematic to use a 29f010 in place of a 27c256? I've tried everything i can think of to get it to work
-bins are stacked properly (verified manually)
-pin 1,2,3,32,31,30,29 to +5v all others 1:1 with the 27c256
using 29f010 in place of 27c256
-
ejukated
- Posts: 426
- Joined: Wed Mar 04, 2009 10:52 am
-
delcowizzid
- Posts: 5709
- Joined: Sat Feb 28, 2009 10:38 am
- Yahoo Messenger: [email protected]
- Location: Wellington NZ
Re: using 29f010 in place of 27c256
https://pcmhacking.net/forums/viewtopic.php?f=13&t=161 there all i did was leave out the pin that correspondes to 28 on a 27C128 which is the notch end right had side pin .i put a 32pin socket on top of a 28pin with 4 pins hanging over the end of the memcal which you can connect where pin 28 would go should give them 5 volts
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem