Hi all, just hooked up my mtx-l wideband and took it for a test on my VT v6 daily. I have a the sensor mounted in a tailpipe attachment. General around town light throttle driving and at idle it reads 14.8 & cruising on the highway it reads 15.6-15.9
Do these readings sound right? I thought the cat converter would make these readings leaner than what its showing as the sensor is mounted after the cat in the tailpipe?
Wideband Readings
- delcowizzid
- Posts: 5632
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Wideband Readings
the tailpipe mounts dont work well
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Wideband Readings
i've never had much experience with tailpipe readings, but the around town cruise stuff should be arounf 14.7 normally and on the highway if your into lean cruise mode it would probably see 15-17's ....
what about when you stand on it ?
what about when you stand on it ?
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Wideband Readings
When I stand on it the readings are around 12.8 - 13.2
- Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Wideband Readings
all sounds within normal readings!
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread