DELCOS NEW RIDE

[Holden202T]

Nice!!

[delcowizzid]

hopefully goes as good as it looks LOL

[delcowizzid]

looks like it should flow ok LOL.

IMGP6892.JPG

while it was out i had a look at the heads a bit more closely.after digging out a 2mm thick layer of carbon i found the port floor of the exhaust port and they have seen some work for sure.ports are very nearly exactly matched to the gasket.and you can tell just looking that they arnt as cast.the valve guides are untouched but they have had a serious look under the seat and in the bowl and along the runners and at a glance looks like hardened exhaust seats .ide love to take the head off and rid the roof of the exhaust ports of the air injection casting/bungs hanging down in the port screaming restriction/turbulance
intake valves look huge through the port and have had work under the seat again and along the runner walls and short turn flattened off.dont use the gasket as a guide its not sitting over the ports properly

IMGP6896.JPG

[Holden202T]

Yeah those air injection bosses are the first thing I do on them heads

[delcowizzid]

wagon got a xmas prezzie about time the 15's got removed LOL.now i just need some springs its uber high looks like an adventura LOL

DSC00006_zps0686b47d.jpg

[Holden202T]

And a tune

[delcowizzid]

must of done something right it spins LOL
[youtube]http://www.youtube.com/watch?v=BuWM3lceFfQ[/youtube]

[Holden202T]

getting close to a boost drive just cooler piping to go ? oh and maybe a muffler hehehe

[delcowizzid]

cooler pipes oil drain into sump instead of a bottle LOL and exhaust

[delcowizzid]

closer shame i cant tig alloy at home im gonna have to farm out this job

DSC00020_zps27ed37fb.jpg

DSC00019_zps54e4d8ed.jpg