CF Bedford Van

[Holden202T]

im sure they do but they also sap a fair bit of HP.

i actually don't have any fan for the motor so i would prefer to go to the electric option.

[Holden202T]

bit the bullet and purchased a mondeo twin fan setup!!

I've been raping some bits out of the ecotec loom I have, knock sensor wire, 4 wire O2 sensor plug, speedo sensor plug etc ... to wire into the V8 loom slowly getting there!

[Holden202T]

One vn v8 loom converted to vr/vs v8 spec with added knock sensor, heated O2, correct speedo sender and camira ignition module!!

Hopefully it all works hahaha!!

2014-04-13 - wiring loom.jpg

[Holden202T]

this is the one brand new http://www.ebay.com.au/itm/Commodore-VB ... 3f27b7c437

got the mondeo twin thermos today ... looks pretty fast should fit in nicely too!! thanks for the info VLT304!

[The1]

Interested to see how it goes, might get one for the vs

[Holden202T]

no time to fully fit it yet but I sat it in there, fits with about 1inch clearance to the water pump !!!! ohhhh yeah!!

[Dylan]

Interested to see how it goes, might get one for the vs

I've had them on a few. Work well.

[The1]

They look like single setup? So id prob just wire them in with a relay and trigger off the high speed fan on the ecu.

[Holden202T]

It's got two separate wires that feed into a 4 pin plug so can do it either way, I'm planning to wire them seperately and utilize the two speed options

[Chuff]

this is the one brand new http://www.ebay.com.au/itm/Commodore-VB ... 3f27b7c437

got the mondeo twin thermos today ... looks pretty fast should fit in nicely too!! thanks for the info VLT304!

Are VB-VL V8 radiators the same as VN/VP V8 radiators?