Jaymes VS Wagon
Jaymes VS Wagon
just picked up ny new car today heres some pics, yes, both ripped off carsales listing, ill go take my own photos tomorrow when theres more light. not currently registered but nice and cheap.
2 windows dont work, supposibly needs a new wheelbearing and link pin rubbers, airbag on passenger side needs its lid gluing back down, needs a wash and a polish and a few other little things, nothign too major.
first job, get it regoed, second job, swap the EFI 304, tricked up TH700 and LSD center from my VL into it. before anyone bothers telling me how much effort it is, I know exactly how much effort that is and I dont care
2 windows dont work, supposibly needs a new wheelbearing and link pin rubbers, airbag on passenger side needs its lid gluing back down, needs a wash and a polish and a few other little things, nothign too major.
first job, get it regoed, second job, swap the EFI 304, tricked up TH700 and LSD center from my VL into it. before anyone bothers telling me how much effort it is, I know exactly how much effort that is and I dont care
Re: Jaymes VS Wagon
Looks fairly tidy ive done the v8 conversion on my vr from a 6 and recently another engine to a 5 speed easy sraight forward drama free but i got everything even the air con lines etc .
electric windows ?
electric windows ?
- delcowizzid
- Posts: 5499
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Jaymes VS Wagon
looks pretty hot mate
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Jaymes VS Wagon
once you do those things to it , should be a nice car!!
post at 10pm, what time did you get back from getting it ?
post at 10pm, what time did you get back from getting it ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Jaymes VS Wagon
got home at 8pm, pretty uneventful run, land rover towed the car trailer at 100k like it wasnt there
dec_head - how did the aircon lines go? im not sure what I need to do to get aircon going... just swap over the v8 aircon lines or get some new ones made or something?
dec_head - how did the aircon lines go? im not sure what I need to do to get aircon going... just swap over the v8 aircon lines or get some new ones made or something?
Re: Jaymes VS Wagon
I went from v6 to v8 with a vr used the same condensor just had to use the aircon lines from from the v8 from under the wipers to the pump condensor etc
Re: Jaymes VS Wagon
effort plus!!! just been tidying things up gettin ready for rego. today, I put all new bushes in the rear end. man those long bushes in the diff are pricks to get out. ended up tearing out the rubber inside with a small peice of threaded rod and pulling the rest out with a giant peice of threaded rod, a bit of pipe and some washers, I was jumping on the bloody spanner every quarter turn winding them out but in the end I WIN
now I just have to put on a new tie rod end and hook all the brakes and shit back up to the diff and I should be on the road.
may have to wind back the chip in it, its got a chip from some performance mob and its running more spark advance than I have ever seen in an ecotec in my mates car, 2 deg less and the knock sensor was going off.
now I just have to put on a new tie rod end and hook all the brakes and shit back up to the diff and I should be on the road.
may have to wind back the chip in it, its got a chip from some performance mob and its running more spark advance than I have ever seen in an ecotec in my mates car, 2 deg less and the knock sensor was going off.
- delcowizzid
- Posts: 5499
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Jaymes VS Wagon
copies for the lads
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
-
- Posts: 1219
- Joined: Sun Mar 15, 2009 10:20 am
- cars: 2004 VYII Acclaim Wagon V6 Auto LPG/Petrol
2004 VYII Berlina sedan V6 Auto
2005 VZ Monaro CV8 manual - Location: Geelong, VIC
Re: Jaymes VS Wagon
Would be interesting to see what they changed?
If it's not knocking i assumed they must have richened it up a bit.
I've been trying a bit of tinkering on my VT, so would be good to see what they've done.
yoda69
If it's not knocking i assumed they must have richened it up a bit.
I've been trying a bit of tinkering on my VT, so would be good to see what they've done.
yoda69
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Jaymes VS Wagon
richening it up .... they're already too rich from what i've seen!!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread