OSE 11P V104

[TTVN]

awesome work guys so happy this is done now
looks amazing much better than expected
love that everything can be controlled off the power/econ switch making it a nice easy transition from nanna mode to skid spec lol

thankyou again we really appreciate the hard work

[VL400]

Thanks mate Yep, the pwr/econ switch can finally be a power mode instead of a pretend just rev a little higher mode

[Dylan]

Could someone post up a pic on where to solder the wire for the NVRAM write line on a 424? When I brought my NVRAM 11P was not around.
I have 2 424's here, might solder one up and sell it off and keep one for "one day". I did look in the 11P zip but didn't find anything.

Any help appreciated.

[Holden202T]

it should be in the nvram setup doco ?

[Dylan]

I didn't get any instructions I brought the board assembled.

[Holden202T]

424 jumper.jpg (221.33 KiB) Viewed 10261 times

[Dylan]

Thanks mate

[pricemyster]

Quick question. With the '699/'424 VR PCM, to run a 14 point 7 spartan do I need to remove a resister to prevent AFR offset reading as in below link or is that only needed in the '808?
http://pcmhacking.net/forums/viewtopic. ... 237#p47237

[Dylan]

I left mine fitted on my 808, it read's fine once I offset the values in 12P. From memory 0v is around 9.5 and 5v is around 21.5.
Good feature of the Spartan the auto sequencer you can get the cal spot on.

[VL400]

In the 11P zip there is a PDF, check out the section wideband AFR. It has instructions on how to remove a 1K resistor to help prevent any offset.