How to loose 200kgs?....

[Gareth]

Progress, I don't normally gloat but that rear firewall panel is fucking awsome

And all the driver controls are done, I'm not sold on the brake pedal position, I might move the clutch to the top of the trans tunnel to give more room for the brakes

[Dylan]

How'd the electric power steering come up?

[Gareth]

Haven't wired it up yet, mechanically it's done, I'm going to add a firewall bracket for good measure (needs a grommet anyway)

[HQ355]

Looks great mate, where and when us next race ? May have to have a look !

[Holden202T]

yeah your right the back seat panel is the business

shes certainly getting close to being back together!

[Gareth]

The goal is to have this ready for the boxing day bash at Daylesford

[Gareth]

These turned up in the mail today from The1, should add that they come really well packaged and the injectors where numbered ready to go, very happy with these

So i pulled those blue ones out,
And found fuel dripping out of this...


That is the vac line for the pressure reg... Explains a lot...

Changed to a VS style rail so as to be able to weld in the dash fitting, i assumed the injector retainer clips where the same, they are not...

[vlad01]

VN-VR clips should fit.

Those VS regs are 3 bar btw, the VT on are 3.5 bar.

[The1]

Be good to see results and how the injectors go!

clips will fit, but are a bit loose, if you want VS-VY Clips i have bag fulls, can put a set in an envelope.

Vlad there are some 3.5bar VS rails out there to, you just have to check the label on the reg.

[vlad01]

Be good to see results and how the injectors go!

clips will fit, but are a bit loose, if you want VS-VY Clips i have bag fulls, can put a set in an envelope.

Vlad there are some 3.5bar VS rails out there to, you just have to check the label on the reg.

Was that late VS?