my ride vt ecotec

[Dylan]

Have you got a wideband hooked up for logging?

[vt3.8lt]

not sure on the part they dont list it on the site some id1000 would be nice not sure if these are but there loisted as bosch peices

http://www.sonicperformance.com.au/BSS1 ... gth/pd.php

[vt3.8lt]

yeah it was but doesnt seem to functoning properly atm i need to look into y but im more concerned about y its not running properly atm

[Dylan]

Wideband would be very handy for this takes all the guess work out of it.

[vt3.8lt]

i just look at the gauge atm its in a pretty visible spot

[Dylan]

In the data stream. Know one else can see the gauge. Plus you can compare it against other data to see if it happens at a certain pulse width or temperature maybe.

[vt3.8lt]

right yeah that makes sence might have a look in the morning y its not working it should be though or it may be not reading right i cant remember

[Dylan]

I got caught on a 424 with wideband input. Removed the pull up resistor on the input and all good.
Details are on the 11P pdf.

[antus]

to test if stuck open remove the injector from the car and key on to prime the pump. if it starts squirting like a hose with no engine running and fuel pressure behind it then its stuck open. Of course im thinking of injectors on the ends of hoses, might not be so easy in your case. Maybe remove a couple and inspect the pintle in the end of the injector and see if they are sitting at the same place.

[vt3.8lt]

i had a go at it when i put the new 424 into the car but maby its not removed properly hay it could be my trouble so ill have another look into it first thing in the mornin its to late to do much now unfortunately