Ecotec Tune With 12P

[holden08]

Well it has been decided we will make a $12P ONLY tune repository.

So if you have any $12P based tunes you've made post them up with as much info as possible ... use my below format if you like to keep things uniform.

File Name: $12P-V1-Ecotec-808.
Code Version: $12P V1.
Engine-Gearbox Type: Stock Ecotec V6 - T700 Auto.
Mods: 2.5 inch exhaust from Y-piece back, 2.5 inch cat and 2.5 inch muffler.
VN V6 MAT sensor fitted just behind TB into inlet manifold.
VN V6 CTS Fitted to stock ecotec location with adaptor.
Heated o2 Sensor fitted after Y-piece.
No A/C or P/S pumps fitted.
VN V6 knock sensor fitted to block in place of one of the original knock sensors.
Injectors: Stock Ecotec V6 (grey tops).
Description: This is a base calibration that should get you going with fitting an 808 ECM to an Ecotec V6, it should work with auto or manual provided its the hydraulic auto.
If you wish to use the ecotec charcoal canister solenoid then connect it to Flex Output A.
Map A is mostly stock ecotec MAF spark table (converted to MAP) and Map B is 98 octane fuel only, connect up the map switch to use this feature, with it disconnected it will use Map A all the time which is tuned for 91 octane fuel.

$12P-v1-Ecotec-808.zip

did you use the vs heated o2 will they work ok on a 808 ecu without any changes

[delcowizzid]

heated o2 works just the same as a single wire or 2 wire sensor just allways stays hot and ready to read accurately.just has 2 wires for power which you run to switched ignition power and earth so its on whenever the engine is

[holden08]

thanks delcowizzid how much for a tune for the 808 running the ecotec is stock but the person this is for wants to put twin throttle body on it thanks

[Holden202T]

there is a link in the first post of this thread which is the tune, you can have it free of charge

[holden08]

i saw that but i need the burner and the gear whitch i dont have and im no good at that stuff im ok at the wiring side software stuff no good at all how much would you charge if you did that for me

[Holden202T]

so what you want to send me a chip and get it erased and re-programmed with that tune ?

[holden08]

yea that would be good how much can you do it for if you supply the chip can you do much to get bit more power the persons car im putting it in he wants to put twin throttle on it dunno if it would do much thanks

[Holden202T]

well the tune as it is now has two maps which you can switch between, one is 91 octane and basically a standard tune, then the other one is a 98 octane fuel only tune which for me did make more power.

other than that you really need to tune the car yourself to suit your combo.

also note i had 2.5 inch exhaust fitted from the Y pipe back ...

if you send me a memcal i'd be happy to unsolder the original chip, put a socket on it and supply the right chip on it that will allow that tune to be put on it for say $60 ... if your interested PM me and we'll work out the details.