DELCOS NEW RIDE

[delcowizzid]

after many months of driving the car on a lean i finally have equal length fe2 springs in the front and took the lowered ones out the rear and fitted FE2 rears in the hope of gaining traction rides nice and smooth but doesnt go anywhere that fast any more single spins so bad after spring change tossing up wether to fit the superlows back in the rear and fit the front superlows i just got to match.also found a split in the map sensor hose thought ide found my stalling issues but nope still dies randomly gah

[delcowizzid]

seems the gts may be a we bit faster if this gtech run is anything to go off .did the same 1/8th time as the wagon but i had my foot right off the gas for the last 2 seconds LOL was just doing a 0-100 test and happened to get the 1/8 by accident

gts v's wagon.jpg (110.45 KiB) Viewed 5592 times

[delcowizzid]

looks like i need to do another run this time ill take the restricter out the inside of the cannon forgot a had the 2" outlet bung up its arse LOL also fixed the huge leak in the crossover from where it had no gasket from the swap over.now comes on boost heaps earlier harder and faster than ever its bloody dangerous definately quicker now

[delcowizzid]

how smooth is a buick without a balance shaft heres your answer
got the vb tuned ready for engineers on monday and did a short vid to show how smooth it is with no balance shaft.its a stock 200000km engine no balance shaft thats a 222@50 duration turbo cam on 60lb seimens idling at 800rpm now who said the buick doesnt idle smooth LOL quite surprising http://www.youtube.com/watch?v=XjvgIqMmPms

[vn5000]

Amazing what a drop of super glue can do .

[delcowizzid]

hahaha nah its sitting there buy itself you can watch it wobble every now and then no tricks there

[vn5000]

Yeah i no i was just joking .You must have it tuned good but ,even a std motor would being pushin to run that smooth , nice work mate.Idont know why they bothered putting those shafts in looking at that.Iremember when i used to blank the balance shafts off the mitsy motors and there would be a very slight vibration at high rpm but nothing to worry about.

[Holden202T]

i've heard the balance shaft isn't a problem if you bring the idle up a bit watch you have to do for most cams anyways

[delcowizzid]

thought ide go do a bathurst day gtech run pulled the restrictor out the cannon went nearly 2 seconds slower due to crazy arse wheelspin i pretty much gteched a powerskid first run 2nd run wasnt much better .also think its raised boost pulling it out as it misses its tits off at full throttle might be awefully lean

[delcowizzid]

well ill be buggered vb passed emmission test and engineers cert peice of piss took less than an hour and it was loaded back on the trailer heading for home again