265 Hemi to efi

[heff0018]

Thanks for the replies, it’s more of an experiment than anything. I have a spare motor and other efi hardware bits lying around and Want to put together a sequential EFI setup for cheap.

[heff0018]

I pretty much found the answer here. Stick with the 808

viewtopic.php?f=15&t=1636

[heff0018]

Hi all, this area had been annoying me for a while and I knew there was something ugly under there. They must of had a rear quarter replaced and where they joined the two panels together was a ton of bog. They just caved the two panels in and stitch welded. When I cut it open it came back a lot closer to the correct position so not so much filler was required. Once I welded it together I filled the welded join area with reofill so its no to be problem again.

RQ1.JPG

RQ2.JPG

RQ3.JPG

RQ4.JPG

Still a bit of work required on the body line.

RQ5.JPG

[Holden202T]

nice job, looked pretty dodgy before hand!

[heff0018]

Thanks Sam, just has got me stuffed why they caved it in so far and why they plug welded it. It took me about 15 minutes to weld it properly. I ground about 1/2 an inch of bog out of the repair and put back in a couple of mm of reofill.

[Macca97]

looks alot better, even for a northshore volvo , its crazy some of the old repairs that were done back in the day

[heff0018]

looks alot better, even for a northshore volvo , its crazy some of the old repairs that were done back in the day

Ha, ha haven't heard that term for a Val before.

[v6bucket]

looks alot better, even for a northshore volvo , its crazy some of the old repairs that were done back in the day

Ha, ha haven't heard that term for a Val before.

Also called a "Marrickville Mercedes"

[heff0018]

Ha, yeah reckon I have heard thAt term before

[Charlescrown]

That repair looks like ones still getting done in local backyards around here. Ended up nice.