BINKY tomorrow

[gtrboyy Profile]

Made a bracket to fit fuel filter bracket which they bought & improved haha

Cool to watch how things get done whether it's Skid Factory,Deboss Garage or Bad Obsession

[immortality Profile]

Xmas special episode!

[delcowizzid]

Was a good Xmas present

[heff0018 Profile]

Sure was, learnt a great trick how they pinned the panel hinge positions for easy refit.

[firebug Profile]

[delcowizzid]

Was quite underwhelmed for there normal quality of work but I guess finding parts over there would be tricky still looks good but not quite as slick as normal

[Gareth]

Really? I thought the zinc plating was great (except the end colour choice)

[VK_3800 Profile]

Was quite underwhelmed for there normal quality of work but I guess finding parts over there would be tricky still looks good but not quite as slick as normal

I kind of thought the same thing to begin with, particularly looking at the pitting on some of the suspension parts. However on reflection it gels with what appears to be their philosophy of not over-engineering things - some of the brackets and metal fabrication is great because they haven't just welded in a massive chunk of thick walled RHS where a folded piece of sheet metal will do just fine for a fraction of the weight. I'm pretty sure they do actually plan to drive it too, they've thought a lot about practical considerations including how to easily remove and maintain parts later on (must admit I'm bad for making things that are hard to maintain). The grey colour is very race-car, function over form.

[heff0018 Profile]

A lot of work just in that rear subframe. No wonder this project has taken so long.

[immortality Profile]

About the only thing left to tinker with is the engine/trans...