PCM questions regarding L67 Swap into VY

[VYL67L03]

This is the one I mean

[VYL67L03]

It's hard to see but it's that angled one at the back of the actuator

[VYL67L03]

Here's a couple more pics I got, sorry the lighting is crap.

[VYL67L03]

This one I blocked you can see the start of the duct tape I made that one a decent sized one, has a bolt screwed into the end of it than duct tape wrapped around it

[vs ss]

EC91FF4F-C8AF-4F8B-901D-76265348EAC0.jpeg

Is that the other end of this hose?

[VYL67L03]

Yes

[VYL67L03]

It's probs 10-15 cm in length and blocked at the end

[Gampy]

I know this is not your current issue, don't want it to become an annoyance later though, A de-barked tree branch of the right diameter is a far better vacuum hose plug then a threaded bolt.

Typically bolts with a shank are to long to stuff into a hose all the way to the shank, unless it's to small, then it will still leak.

Can't count how many times I've seen/fixed a rough idle do to a bolt used as a vacuum hose plug.
Very common in the carb. base plate days ...

[vs ss]

Ok well that’s good. Just do some testing tomorrow and see how you go.

[VYL67L03]

Ah yep cheers mate it's only temporary just trying to get it started