16198259 corvette

[keto]

yea $12p v8, only problem is i don't have a eprom burner, havent been able to find one

are there any members in auckland, new zealand? maybe i could get someone else to load it for me

i must also have something wrong with my usb board aswell or i would be able to connect to a normal memcal but not edit it correct?

[Jayme]

not nessesarily... VN code wont work over the 8192 usb board, only VR > will work with it. whats the code of the stock memcal you are trying to use?
delcowizzid lurks somewhere in NZ.... thats about all I know of

[keto]

the ones that work are ATPW so $A5 And APDL which i have no idea
also have BKCY which could be $12p or more likley $11p
and a AKHA from the corvette, which i have no idea on the code

[delcowizzid]

BKCY is v6 .if your nvram is corrupted i can flash base 12P back in im sure vl400 would of put 12p on both halves of the nvram so you could pull the jumper off to swap tunes and should be on another complete bin file that should be fine

[keto]

yea vl400 loaded both banks, i've tryed both banks and every setting i can think of in the flashtool and still can't get anything, even hooked the extra 12v upto the usb incase it made a differance, one thing i did note was that the blue light on the nvram is only on when one of the map's is selected... is this normal?
heres a screenshot of my settings and a print-out of what the info screen says

i think i might send it down to you to reload if you don't mind delcowizzard?


11:07:23 PM Searching For OSE Device...
11:07:23 PM Searching For ECM...Attempt 1...
11:07:23 PM Request Sent
11:07:23 PM Searching For ECM...Attempt 2...
11:07:23 PM Request Sent
11:07:23 PM Searching For ECM...Attempt 3...
11:07:23 PM Request Sent
11:07:24 PM Searching For ECM...Attempt 4...
11:07:24 PM Request Sent
11:07:24 PM Searching For ECM...Attempt 5...
11:07:24 PM Request Sent
11:07:24 PM No ECM/PCM Found
11:07:24 PM No Response
11:07:24 PM Not Enabling ECM Chatter
11:07:24 PM Not Enabling BCM Chatter
11:07:24 PM No Devices Found
11:07:24 PM COM5 closed
11:07:24 PM COM5 already closed

[Holden202T]

if your gonna do that send the whole ecm, delcowizzid should be able to burn and test that he can connect to it, if he can and you can't that will narrow down the issues!

[delcowizzid]

good thinking

[keto]

will pm you, thanks

[VL400]

Yep loaded the NVRAM with 12P and tested just the DS1245Y on my bench setup before sending it off. The blue light is an indication for which bank is in use but also helps to show power when on the lower bank, so with the jumper off the LED should always be off too.

[keto]

thats good about the light, (i did follow the tracks and think that was the case) hopefully its something simple that i overlooked....

i'll send it down to mr wizzard today and see if he can shed some light