16198259 corvette

[keto]

haha mint!! that should give me a awesome starting point!!!! and heres a rough pic to show you what were working with

now off to the shop to buy more bends for the cooler and wastegate piping

[Holden202T]

looking like its not too far away from being done!!

[delcowizzid]

posted it today mate have a tracking number if you need it said 1-3 days so hopefully 2 days away

[keto]

cool, thank you soo much for sorting that out!!!

i have pencil'd in some dyno time for next week, got a heap more done today, can't wait to see what she goes like

[keto]

engine bay is getting more full by the minute, 10-12hour days seem to help the progress
just got to mount the actuators, route the oil return, fab up some more brackets and mill a tiny bit outta one manifold and i think shes good to roll, then tidy and heatwrap once shes gone for a few drives

[Holden202T]

you may have already seen this, either way, bit of inspiration for ya

Gup's Turbo HQ Video

[keto]

yea i saw it last year when they brought it over for powercruise... did a 600m powerskid, i couldn't get over the sound when he sits there getting the turbo to spool, its unreal!!!!!

[delcowizzid]

get that ecu and tested it yet says delivered on nz post

[keto]

yep it turned up yesterday so we pulled all the piping apart did all the final tidying/grinding/cleaning of pipes and assembled with gaskets etc and at about 2.30 this morning plugged the loom in and she started right up, but was way to loud to let it run for long so didn't get to try laptop etc, it sounded quite angry, going back there now to keep working and see if we can clock some k's

don't get the interior back till sunday and the guy took our spare seat so i have to temporarily make some other seats fit

[delcowizzid]

haha thats how its done mate early morning fireups after a hard slog are the best ones