Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Thu Jun 04, 2015 7:16 pm
have you tried another computer ?
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
VS Ecotec, Flooding one bank of cylinders??
Page 2 of 2
Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Thu Jun 04, 2015 10:13 pm
Not yet, no...
Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Fri Jun 05, 2015 12:42 pm
I dont think you will be able to run another computer because the key on - 10 second wait - key off is the kalmaker security doing its thing and the tune will be married to that pcm, another will need a re licence.
Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Fri Jun 05, 2015 12:55 pm
Ahhah...!!! Thanks Antus, so it wasn't bullshit then 
Still, do you know of how the original problem may happen in the software?
Still, do you know of how the original problem may happen in the software?
Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Fri Jun 05, 2015 3:50 pm
yes holden targeted WOT @ 12.10, they put an adjustment in the Power Enrichment - Trim V's RPM table so it's trims the 12.8 AFR target set, just set them back at 0 and you' get your 12.8 target back.
Re: VS Ecotec, Flooding one bank of cylinders??
Posted: Sat Jun 06, 2015 9:09 am
Kalmaker is 1min on, 1 min off for security reset. Could have created a tdm issue there and depending on the type of memcal you're running could be corrupt. Are you running an NM27c010 or DS1245Y?