Re: Vt getrag speedometer
Posted: Sun Nov 10, 2019 3:13 pm
There is no loom for it so I'm trying to get it going by itself to fit it to my dash in the vk
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
Vt getrag speedometer
Page 2 of 3
Re: Vt getrag speedometer
Posted: Sun Nov 10, 2019 3:19 pm
You might need to flash a VS3 calibration to get the speedo output working from the ECU
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 3:14 pm
- Can anyone identify this ecu ,its out of vs 1998 auto 5l vats deleted and "stage 2 chip" whatever that means ,maybe then I can look up wiring inputs outputs and hook speedometer up
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 3:20 pm
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 4:56 pm
Dunno about the tune but its an 11p capable 424 maybe with 11p and the auto dtcs masked.
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 6:09 pm
Yea no idea what that means, I might have to do some learning before I can figure this one out haha 
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 6:10 pm
The car runs great though and doesn't have any running issues ,basically it's a vk with a vt block and getrag290 with 98 vs v8 auto ute used as the donor for all the loom and gear etc
Re: Vt getrag speedometer
Posted: Mon Nov 11, 2019 8:13 pm
Get a Dakota Digital SGI5E. Convert the signal type and the pups count all in one.
Re: Vt getrag speedometer
Posted: Tue Nov 12, 2019 9:17 am
I'll look at that thanks
Re: Vt getrag speedometer
Posted: Fri Nov 15, 2019 10:06 pm
Had vs s3 manual in lc torrie...not looked in awhile vaguely remember manual harness & ecu different to auto also read somewhere here that signal of speedo sensor is different.
When first got mine running couldn't fit speedo sensor in torrie tunnel so would intermittently pop up that fault code...rare occasions stalled when stopping at slow speeds.Never happened with sensor fitted after tunnel was clearanced.
Can't recall if it was a vs v8 diagram thread or conversion forum.
So I'd say something like signal convertor as Dylan suggested & memcal modded to suit manual.
When first got mine running couldn't fit speedo sensor in torrie tunnel so would intermittently pop up that fault code...rare occasions stalled when stopping at slow speeds.Never happened with sensor fitted after tunnel was clearanced.
Can't recall if it was a vs v8 diagram thread or conversion forum.
So I'd say something like signal convertor as Dylan suggested & memcal modded to suit manual.