pcmhacking.net

I don't know if this is a bug: (or me being stupid)

My 4 Cylinder memcals, I wrote a bin bin file that I've edited in TP which is set to 4 cylinder mode and the like, Yet with the current (2 Bar) ADX file in SP it, it detects my memcals as 8 cylinder ones, in 4 cylinder mode.

My resistor network chips are: 16067752 and 16067753, which I always assumed where 4 cylinder backup mode chips?

it will say 8 cylinder until the car is running then should goto 4

nice work with the ose 12p.just a quick question will it work with an 808 ecu.i know there wont be any datalogging.also with the single fire mode does it have a injector ms setting so under a certain injector ms it will single fire then over that it will double fire.thanks darren

sure will mate

Yeah the single/double fire is done using two settings. The Run A/F Params - Minimum BPW for sync delivery and Run A/F Params - Minimum BPW Hysteresis. Set the first one to the min PW you want before switching to single and the hystresis to a value higher than that to switch back to double fire. Also, these have been renamed for the next release to something more meaningful.

ok.thanks for that.hope everyone is well.bye for now.darren

VL400 wrote:Run A/F Params - Minimum BPW Hysteresis. Set the first one to the min PW you want before switching to single and the hystresis to a value higher than that to switch back to double fire.

That might be why mine wasn't working

Does anyone know if there is a flag or bit in the aldl stream that signals when you are using map A/B with $12P .

Not in V104 but it will be in V105 Its part of the changes for getting some generic inputs

vn5000 wrote:Does anyone know if there is a flag or bit in the aldl stream that signals when you are using map A/B with $12P .

There is if your running methanol, AFR's go from 14.7 to 6.4