FX Holden Race Car Project

[immortality]

It seems to be a bit of a trend with your builds at the moment.

[Holden202T]

Yeah i know, this one shouldnt be as bad as the bedford though!

[Holden202T]

Turbo fits
Will probably rotate the turbo to be more straight and thinking i'll most likely send the exhaust out the inner guard too, should help get the exhaust heat away from the inlet and help with under bonnet temps!

WP_20160917_13_41_44_Pro.jpg (328.72 KiB) Viewed 5148 times

WP_20160917_13_41_37_Pro.jpg (259.71 KiB) Viewed 5148 times

[Holden202T]

this arrived today, unfortunately there is a lot to do before i can use it!

notch master.jpg (75.04 KiB) Viewed 5126 times

[Gareth]

Like what? Looks like a nice bit of gear aside from the cheap looking hole saw...

I'll get those boot hinges in the post this week, this thread just reminded me why they're sitting on my bench

[Holden202T]

Well for starters i need to get roll bar pipe, but then i cant install that till i have the chassis rails in and the 4 link rear end

[vlad01]

how does a 4 link work as oppose to a 5 link?

[Holden202T]

I assume by 5 link you mean panhard bar as the 5th link ?

http://www.mcdonaldbrosracing.com.au/4link.html

[vlad01]

I assume by 5 link you mean panhard bar as the 5th link ?

http://www.mcdonaldbrosracing.com.au/4link.html

yes thats what I mean. So basically its just a 5 link with different definition used.

[Holden202T]

Call it what you want, everyone else calls them a 4 link!