Page 3 of 4
Re: Turbocharging the ecotec motor
Posted: Sun May 11, 2025 6:14 am
by Muncie
@Rhysk94
It should be in the 13s i know, 14.1 was with all my tools in boot ready to pack it in for day.
https://youtu.be/eWOA4Rt0Z4Q?feature=shared this was at meremere
Was first time I've raced it since Turbo'd and I'd put adjustable suspension in the day before had no time to work that out.
But it towed a trailer to the track and home again did hotlaps with passengers and only ended up with a cracked crossover pipe for all the punishment.
Way more in it.
Re: Turbocharging the ecotec motor
Posted: Sun May 11, 2025 6:14 am
by Muncie
.
Re: Turbocharging the ecotec motor
Posted: Fri May 23, 2025 3:53 am
by upyas
Muncie wrote: ↑Sat May 10, 2025 1:53 pm
Mines been running a GTX3584RS for almost a year at 10-12psi good fuel system and good fuel it honestly seems unfazed I've drag raced it on slicks and even the Auto doesn't seem to care about the power it shifts quickly doesn't slip and has between 400,000ks to 500,000 ks on engine and trans.
Trans has a Corvette servo and synthetic fluid and I've spent more time tuning the trans then engine, it's a no trainer you should absolutely do it.
would you share a file with your trans settings please?
Re: Turbocharging the ecotec motor
Posted: Sun Jun 01, 2025 8:28 am
by Muncie
@upyas
This is an old file but has been down the strip
Re: Turbocharging the ecotec motor
Posted: Sun Jun 01, 2025 4:29 pm
by Rhysk94
Re: Turbocharging the ecotec motor
Posted: Sun Jun 01, 2025 8:11 pm
by Rhysk94
Muncie wrote: ↑Sun Jun 01, 2025 8:28 am
2-2-2025 Backup.bin
@upyas
This is an old file but has been down the strip
I hope to god this isn't the tune file for the turbo car, unless if I had the wrong xdf, the timing in that
Re: Turbocharging the ecotec motor
Posted: Mon Jun 02, 2025 11:04 am
by Muncie
He only wanted trans settings.
*edit*
Please run this as is you want an easy way of inspecting your big end bearings as i don't know what else is in there.
Only posted for trans settings.
Re: Turbocharging the ecotec motor
Posted: Tue Jun 03, 2025 9:35 am
by Rhysk94
Re: Turbocharging the ecotec motor
Posted: Tue Jun 03, 2025 5:49 pm
by Wade
This is the trans setting's in mine. Pretty happy with them, But also like to point out it's not turbo and has changes for the mace throttle body and thermostat. Also fitted with a transgo pro shift kit on the softer setting's. So didn't drill the valve body separator plate.
Re: Turbocharging the ecotec motor
Posted: Tue Jun 03, 2025 6:24 pm
by immortality
Shift kits make a huge difference.
I remember when my mate did his, I had to pull out a heap of low end line pressure although he probably went straight to hard setting with the Transgo kit.
