Re: Trigger points for CAS.
Posted: Tue May 06, 2014 5:54 pm
Yes two wires.
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
Trigger points for CAS.
Page 5 of 18
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:08 pm
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:09 pm
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:10 pm
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:13 pm
The skyline sensor fits in but the screw that holds it is out too far, but as the cable that comes with it is like 2 ft long I might make it fit and hopefully it reaches the module.
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:33 pm
just be careful with that, i tried using the balancer with slots in it for the trigger and it was "flakey" also they tend to spin when old!
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 12:45 pm
You can extend the wires if needed, just use shielded cable.
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 1:08 pm
Not using the balancer as you already told me not too, haven't made the wheel yet just spaced the gilmer pully out from the balancer and I won't weld the bracket on until the wheel is in place.
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 1:15 pm
I was told you could use the shielded audio cable from Jarcar as I have heaps of it can it be used?
Re: Trigger points for CAS.
Posted: Thu May 08, 2014 2:10 pm
i used shielded microphone cable from them, approx 1.5 mtrs then 20 cm lead from the sensor thats not shielded, haven't had any issues!