My Delcoed Rides

[Holden202T]

i would have to have a look on the doco i got but that sounds familiar, i actually had the right size drill that i had snapped so i measured it and i THINK it was just bigger than 3.5mm so i used a 3.5mm drill

either way its about double the size of the original hole!

[v6bucket]

5/32" is between 3.9 & 4mm.

[Holden202T]

yeah thats probably in then, i chose to go for the smaller metric over anything bigger figuring the fact the hole had pretty much doubled in size was going to make a suitable difference anyways!

[Holden202T]

well the good news is i put the tranny back in and filled it with oil and 1. nothing leaked out and 2. it slammed into drive

[VL400]

Excellent

[Holden202T]

the next phase of development is underway speedflow fittings welded to the tappet cover front and rear!

P1100637.JPG

now i just need to complete the dear part .... the fittings and catch can.

[delcowizzid]

hows she coming along mate

[Holden202T]

well i got a muffler for it today, going to be putting it on one day when its not so freakin hot!!

need to get more parts for the catch can but shes slowly coming along.

[Holden202T]

minor progress update!

P1100657.JPG

finally finished!!

i've also ordered the oil breather tanks and associated fittings so hopefully that will be sorted in the next few weeks then theres really not too much actually stopping me from going to the drags again

[delcowizzid]

is that a flowmaster copy we used one of them no good on turbo they glow red hot where all the internal baffles are and burn the shape of them in the outer casing LOL not to mention the huge power loss.just dump a 3" pipe out behind the front wheel its all it needs for racing or our street exhausts have 2 hotdogs only no fluted ones