Re: FX Holden Race Car Project
Posted: Mon Jun 11, 2018 6:11 pm
How's that go down? I love the real one it's probably my favourite.
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
FX Holden Race Car Project
Page 95 of 144
Re: FX Holden Race Car Project
Posted: Mon Jun 11, 2018 8:57 pm
yeah me too, its all i get at the local pub, the home brew version when i do it right is very very close!
Re: FX Holden Race Car Project
Posted: Thu Jul 05, 2018 2:06 pm
Making good progress on the sheeting, 4 link is totally covered now, boot flooring is all but done, only needing the side and base on the right done where you can see the beer case template.
You might be wondering what the thing is sticking up, that is the battery hold down clamp thingy, it had to go in before the floor sheet went in as it turns 90 degrees under the floor and goes into another hole in the angle iron support.
And yes I'm having a lot of troubles with reference keg pressure!
- P1000430_1530763032738.JPG (304.52 KiB) Viewed 4612 times
- P1000429_1530763032004.JPG (218.96 KiB) Viewed 4612 times
Re: FX Holden Race Car Project
Posted: Thu Jul 05, 2018 4:08 pm
White collar worker
Re: FX Holden Race Car Project
Posted: Sun Jul 08, 2018 2:21 pm
Is there any beer in your glass?? 
Re: FX Holden Race Car Project
Posted: Sun Jul 08, 2018 7:13 pm
its fucked man, i think the brew is just too fizzy, its slowly getting closer, probably doesnt help i also poured it then walked straight out to the shed with the camera!
Re: FX Holden Race Car Project
Posted: Mon Jul 30, 2018 10:16 am
little bit more progress over the weekend, got the "back seat" cut out and mostly installed!
Re: FX Holden Race Car Project
Posted: Mon Jul 30, 2018 1:13 pm
these references are getting dodgy I'm not sure whether that's a 4 x 2 or 3 x1/1/2 
Re: FX Holden Race Car Project
Posted: Mon Jul 30, 2018 1:15 pm
Nah, they're 3x3 for sure....
Re: FX Holden Race Car Project
Posted: Mon Jul 30, 2018 1:36 pm
lol sorry about the dodgy reference!