I need help to figure out a schematic to make a cable for programming a bike ignition.
The only info i could find is this made by the same company but not for my ignition http://www.raptorforum.com/forums/showt ... hp?t=46683
And this wich is a picture the green and purple are used to connect to the tacho wire and voes wire for programming white was the 12 volt ignition end so i assume black would be the earth
after looking at the other connector from the same company with the 9 volt battery is the above circuit just a voltage regulator or something more sinister
Figuring out a programming cable schematic
-
js1973
- Posts: 58
- Joined: Fri Nov 19, 2010 2:23 am
- cars: wh statesman
Figuring out a programming cable schematic
You do not have the required permissions to view the files attached to this post.