Page 1 of 2
VS V6 & V8 PCM Wiring Diagram
Posted: Fri May 27, 2011 4:46 pm
by VL400
Re: VS V8 Auto Wiring Diagram
Posted: Fri May 27, 2011 7:50 pm
by The1
Re: VS V8 Wiring Diagram
Posted: Fri Jul 29, 2016 11:06 pm
by monkies5L
hey sorry guys, my VS S2 and my VS BT1 looms dont have a knock sensor on them, what could be the difference there?
Re: VS V8 Wiring Diagram
Posted: Sat Jul 30, 2016 3:25 am
by immortality
Only HSV used the knock sensor/have the wiring in the loom.
Re: VS V8 Wiring Diagram
Posted: Sat Jul 30, 2016 8:01 am
by Dylan
It's actually a seperate run wire on these model's. Not a part of the engine harness.
Re: VS V8 Wiring Diagram
Posted: Tue Aug 02, 2016 7:18 pm
by monkies5L
so would it matter at all if i wired a VT roller cam into VS ute with standard VS V8 loom without knock sensor?
Re: VS V8 Wiring Diagram
Posted: Tue Aug 02, 2016 7:30 pm
by Dylan
No so long as the knock sensor is disabled in the tune.
Re: VS V8 PCM Wiring Diagram
Posted: Mon Jan 16, 2017 2:27 am
by Wade
I fitted a vt roller engine into my brother vq. Just run all your accessories and intake manifold along with you engine loom on the vt motor and your done.
Re: VS V8 PCM Wiring Diagram
Posted: Mon Jan 16, 2017 2:40 pm
by Holden202T
why do you need to run the earlier inlet manifold ? I would have thought they were the same ?
Re: VS V8 PCM Wiring Diagram
Posted: Mon Jan 16, 2017 2:47 pm
by Dylan
No IAT sensor thread and only 1 temp sensor thread at the Front. Probably missing the vac port for MAP to can't remember that one.