I'm about to drill and tap my plenum to fit an IAC sensor that was liberated from a N13 pulsar - it has '1300' stamped on the hex flats, and PED/71 cast in the grey plastic socket.
Does anyone know off the top of their head what thread it is? It doesn't look like BSP/NPT as I was expecting, more like M14x1.5?
IAT sensor thread?
-
- Posts: 440
- Joined: Sun Mar 22, 2009 11:52 am
- cars: VT V6 supercharged in a corolla
- Location: Sydney
- Contact:
Re: IAT sensor thread?
M14 X 1.5 sounds right for IAT. From memory the CLT sensor is M12
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: IAT sensor thread?
yeah m14 x 1.5 rings a bell, i had to go and buy a tap specially for that purpose.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: IAT sensor thread?
Thanks - of course it was going to be M14, because I don't have that size tap