IAT to MAT
-
Jervies
- Posts: 199
- Joined: Wed Nov 09, 2011 5:35 pm
- cars: Vt v6 wiith a gt35/40 turbo e85 399rwkw
Mazda e2000 with a cammed vx ecotec motor - Location: Victoria
IAT to MAT
Im wondering if the outputs for the iat sensor are the same for a mat sensor? Iv changed the iat to a mat sensor in the manifold on my mafless turbo setup (i dont know why it wasnt done in the first place) im wondering if the values im seeing in efilive are still going to be correct? Cheers
-
antus
- Site Admin
- Posts: 9018
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: IAT to MAT
To find out turn the key on when the car is cold and not running, should get a pretty close reading on CLT ant IAT since everything should be room temp.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
-
Jervies
- Posts: 199
- Joined: Wed Nov 09, 2011 5:35 pm
- cars: Vt v6 wiith a gt35/40 turbo e85 399rwkw
Mazda e2000 with a cammed vx ecotec motor - Location: Victoria
Re: IAT to MAT
Gave it a go this morning and a thermometer on top of the plenium was reading 14 same as the MAT sensor so works a treat 
i logged it with efilive on my turbo vt and im getting intake temps about 10/15 degrees above ambient temp.
Cheers
i logged it with efilive on my turbo vt and im getting intake temps about 10/15 degrees above ambient temp.Cheers