VN BT1

[rxfc3s]

Howdy guys,
Been a member of the site for awhile, more a lurker than a contributor but thought I would share my ride, a 1990 VN BT1
I would like to use the car as a daily/cruiser/occasional off street 1/4 1/8 mile type racing.
Currently I'm rebuilding the auto trans with a few goodies and also fitting 4.11 gears in the rear end.
Plan is to purchase a NVRAM board and do some data logging and learn to tune the Delco.
I'm also looking at upgrading the cam, either a Crane 268H or 276H not sure yet, anybody with experience able to chime in? Car also runs extractors and is stock otherwise

Cheers
Andrew

[v8-tuning]

Get some pics up! Id go the 276 or even crow 4502 perfect for stock comp 304's.
Im about to install one.

[delcowizzid]

standard 304 ide run a 276 or 284 if keeping bananas .and some valvesprings are a must we emasured old stockers at 40lb seat pressure LOL.we run a kelford cam here in nz which is pretty much a 284 crossed 276 its [email protected] duration on 112 lsa

[Holden202T]

yeah i agree definately need some springs, if your going to pull it apart may aswell get the comp up near 10.5:1!!