VS HSV 5.0 Manual XDF $5A

[zspanners]

Help , I cannot seem to be able to find an XDF for this vehicle.
VS HSV V8 Manual 16206305 ECU with a BMZL bin file.
Can anyone point me in the right direction please.

Thanks.
zspanners.

[Dylan]

Would of thought $12 Code for that

[Dazza92VP]

looks like a seriesIII maf based system if its using bmzl and 305 ecu try this

$A6 VS V8 Series 3 V1.01.xdf

found it in the memcal id tool hopefully should work for you

[antus]

I agree with Dylan, replace with 12p, just turn on echo via access via the aldl port, or leave echo off if tuning with a modified 808. The tune will run fine on the 16206305 ecu when your done. Just remember to set the flags for VS vats.

[zspanners]

Hi Antus , 12 P would be the gun choice however for a minor tweak to the STD file this is a bit excessive !!!.
To convert over to 12P and remap the whole thing is not a five minute job to get the best results.

We only need to rescale for slightly larger injectors and a minor bit of bottom end VE fine tuning to suit a very mild cam.

Does any one have a $5A File?.

zspanners.

[Holden202T]

that sounds to me like enough justification to go to $12P

the adx above not suitable ?

[zspanners]

Trying to help out a newbie interstate with a near stock vehicle.
Cannot justify going 12P for very minor mods and he is new to Tuner-Pro and Delco tuning.

If I was doing this in my Dyno shop I would use 12P no problems.

Zspanners.

[VL400]

Use the $12 XDF, it should line up with $5A - providing the xdf "16183082 $12 xdf version 1.zip" from http://pcmhacking.net/forums/viewtopic.php?f=7&t=5 is ok. I have not used it but the VE looks correct as the 2400RPM rows of the low/high RPM tables are the same.

[zspanners]

Hi VL400 , thanks , that looks to be usable at the moment.


PS any further development on our other little ( or not so ) project.
VS SC V8 Auto.

Zspanners.