Page 1 of 1

Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Mon Apr 21, 2014 11:03 pm
by Circlotron
I read the the Tip-In Bump spark feature is used to reduce the driveline clunking when going from very light throttle low speed drive to overrun with a manual trans. If I wanted to disable this feature for the sake of experiment because I have an auto tranny, what's the best way? Just zeroing all the values in the tip-in table?

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Mon Apr 21, 2014 11:13 pm
by vlad01
un-set the RDSC flag. RDSC is the main feature that the tip in/out bump works from?

I have it off normally because i like he very over the top response and sharpness.

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Mon Apr 21, 2014 11:26 pm
by Circlotron
Coolarama! Thanks for that.

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Tue Apr 22, 2014 1:02 pm
by Circlotron
There is no RDSC flag. Plenty of scalars but no flag :?:

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Tue Apr 22, 2014 10:48 pm
by vlad01
should be?
try searching RDSC and see what it comes up with

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Thu Apr 24, 2014 12:47 pm
by Circlotron
Nuh, no flags, only scalars. Could this be it?

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Thu Apr 24, 2014 1:23 pm
by Holden202T
i'd say you need to change one of the temp enable scalars for it!

like increase this to max temperature....

RDSC - Minimum Coolant Temp To Enable RDSC

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Thu Apr 24, 2014 1:34 pm
by VL400
Or the flag "Map A: set=RPM derivative spark control option"

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Thu Apr 24, 2014 1:57 pm
by vlad01
VL400 wrote:Or the flag "Map A: set=RPM derivative spark control option"

thats the one!

Re: Disabling 12P Tip-In Bump spark and auto tranny.

Posted: Thu May 15, 2014 10:19 pm
by kilebantick
The flag you're looking for is "Map A: set=RPM derivative spark control option". Un check the checkbox to disable RDSC :)

Edit: Teaches me not to read all the comments thoroughly! Beaten by VL!