Disabling 12P Tip-In Bump spark and auto tranny.

[Circlotron]

I read the the Tip-In Bump spark feature is used to reduce the driveline clunking when going from very light throttle low speed drive to overrun with a manual trans. If I wanted to disable this feature for the sake of experiment because I have an auto tranny, what's the best way? Just zeroing all the values in the tip-in table?

[vlad01]

un-set the RDSC flag. RDSC is the main feature that the tip in/out bump works from?

I have it off normally because i like he very over the top response and sharpness.

[Circlotron]

Coolarama! Thanks for that.

[Circlotron]

There is no RDSC flag. Plenty of scalars but no flag

[vlad01]

should be?
try searching RDSC and see what it comes up with

[Circlotron]

Nuh, no flags, only scalars. Could this be it?

[Holden202T]

i'd say you need to change one of the temp enable scalars for it!

like increase this to max temperature....

RDSC - Minimum Coolant Temp To Enable RDSC

[VL400]

Or the flag "Map A: set=RPM derivative spark control option"

[vlad01]

Or the flag "Map A: set=RPM derivative spark control option"

thats the one!

[kilebantick]

The flag you're looking for is "Map A: set=RPM derivative spark control option". Un check the checkbox to disable RDSC

Edit: Teaches me not to read all the comments thoroughly! Beaten by VL!