innovate lc-2 integrated to 808 12p?

[vn304turbo]

Is this the right wideband to use?

http://www.innovatemotorsports.com/products/lc2.php

Looking for the right one to use with tunerpro and nvram '808 12p?

[vlad01]

yeah that should be fine.

[antus]

Yeah that or an MTX-L if you want an in cabin guage.

[vlad01]

that is what the 2nd output is used for yeah?

[antus]

yeah, but its a second purchase. If you buy the MTX-L its all in one. But it depends what you want. Probably is reasons for going either way.

[vn304turbo]

Yea wouldnt mind keeping an eye on afr's atleast for a while so it will be a permanent install with a guage. Was thinking about the digital guage lc-1 (or 2 whatwver it is now) kit for about 240 but I do prefer the needle guage type display. So the mtx-l with also give me a guage and the the output sig for the ecu?

[Holden202T]

MTX-L has the digital display gauge plus a sweeping gauge of lights around the outside edge ....

you can see it in this video, bottom gauge ... http://www.youtube.com/watch?v=wFmttL-ClyU and don't worry about the flickering display, that's just my camera, its not like that when looking at it normally.... you can see when I gas it the sweep goes to the left (rich) and then swings back to the right (lean) when I get off the gas

aside from the connection for the gauge, the MTX-L also has 2 analog outputs (fully programmable) which can be used for connecting to the delco or simulating narrow band sensors etc.

im not sure if you can actually get a needle type gauge for any of them though.

[vn304turbo]

Seems legit, couldnt see so well in the vid but I get the general idea. You said its got the analog out I need for the delco and the guage in one unit which are really the only things I require, needle type guage is just a preferance. Think ill get one of those for the sake of simplicity and i like the addition outside ring on the mtx-l over the basic looking lc-2 db Thanks heaps mate

[Holden202T]

yeah basically, MTX-L if you want a gauge, LC-2 if you don't want a gauge as far as I can see!

I've been involved in 4 MTX-L's and one LC-1 and can't say a bad thing about innovate!