Hi guys,
I am looking at supercharging a Holden 304 and am looking into water injection however kits are way too expensive ... Rather Thanks running a Hobbs switch and set to x PSI and have the same water flow from x PSI to limiter I was wondering if there was a cheap way of say adjust voltage to PSI or rpm to stage water injection..
Tha ks
Daniel
rpm or vacum to voltage
-
Vpgts076
- Posts: 97
- Joined: Wed May 09, 2012 12:57 pm
- cars: vp gts
-
VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 4:54 am
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
Re: rpm or vacum to voltage
If you are using 12P then one of the flex outputs can be setup to do that. Can be mapped against anything, for water injection MAP vs Charge temp or MAP vs RPM might be a good way to set it up.
There is info on setting up the flex tables here .. http://pcmhacking.net/forums/viewtopic.php?f=28&t=3051
There is info on setting up the flex tables here .. http://pcmhacking.net/forums/viewtopic.php?f=28&t=3051
-
Vpgts076
- Posts: 97
- Joined: Wed May 09, 2012 12:57 pm
- cars: vp gts
Re: rpm or vacum to voltage
Hi mate ,
Currently running kalmaker n/a tune as supercharger isn't installed.
Who is the best person in Melbourne for $12p tune?
Currently running kalmaker n/a tune as supercharger isn't installed.
Who is the best person in Melbourne for $12p tune?
-
antus
- Site Admin
- Posts: 10015
- Joined: Sat Feb 28, 2009 10:34 am
- cars: TX Gemini 2L Twincam 8psi
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B
Subaru WRX 2007
Re: rpm or vacum to voltage
For reference, if you've got an eprom writer that supports the nvram you can put 12p on the kal hardware and use that.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396